1865 Queen St E, The Beach, TorontoOpen 24 hours, 7 days(647) 956-6043
Electrician SelectToronto · The Beach(647) 956-6043

Electrician Select Toronto · Queen St E

Pot light installation for east-end homes

Slim LED pot lights laid out for the room, on dimmers that don’t flicker, with neat holes in plaster or drywall. Living rooms, kitchens, basements, bathrooms and exterior soffits.

Layout first

Good pot lighting starts with a plan, not a grid. We look at where you sit, cook and walk, where the furniture and cabinets go, and what the ceiling framing allows, then space the lights so the room is evenly lit without glare on the TV or shadows over the counter. In a typical east-end living room that might be a perimeter layout set back from the walls. In a kitchen it means lights lined up over the counter edge, so you are not working in your own shadow.

Plaster ceilings and older houses

Many homes in The Beach, Kew Beach and around Gerrard and Coxwell still have original lath-and-plaster ceilings. Plaster cuts differently from drywall and can crack or pull away from the lath if the work is rushed. We cut with the right tools, fish wire between joists through small access holes where we can, and keep openings tidy for patching. Ceilings under an attic need IC-rated, airtight fixtures, so they can sit in insulation without leaking warm, moist air into the attic.

Choosing the lights

Most of what we install are slim LED wafer lights, which need no housing and fit shallow ceilings. A few choices make a big difference:

  • Colour temperature: 2700K to 3000K feels warm in living spaces; 3500K to 4000K is crisper for kitchens and work areas. Colour-selectable fixtures let you decide on install day.
  • Size: 4-inch lights look cleaner in most rooms; 6-inch suits high ceilings and big open spaces.
  • Dimmers: LED-rated dimmers matched to the fixtures, so the lights dim smoothly without buzzing.
  • Wet locations: wet-rated fixtures over showers and tubs.
  • Exterior: soffit lights for the front of the house and the walkway, often on a timer or photocell.

How a pot light job goes

  1. Send photos. A few photos of the room and ceiling, and roughly how many lights you have in mind. We will tell you what is realistic.
  2. Plan the layout. We mark positions on the ceiling with you before anything is cut, and agree on switch and dimmer locations.
  3. Install. Cut, fish, wire and mount. Most single-room jobs are done in a day, and we clean up the dust before we leave.
  4. Test and walk through. Every light and dimmer tested together, with a walkthrough of the switching before we wrap up.

Pot light questions

Will there be holes to patch?

We keep openings small and tidy and tell you upfront where any access holes will be. Ask about patching when you call, and we will tell you what is included for your job.

Can you add pot lights without attic access?

Usually, yes. Wafer LEDs need very little depth, and wire can be fished between joists from one opening to the next. Joist direction and blocking decide how many small access holes are needed.

How many pot lights does a room need?

It depends on ceiling height, room size and how bright you like it. A rough starting point is one light every four to six feet, but we lay it out to the room rather than using a fixed formula.

Can pot lights go in a bathroom?

Yes. Fixtures above a shower or tub must be rated for wet locations, and the bathroom circuit has to meet the code requirements for that space.